SolarNode is syncing! Yes, you can run a #Bitcoin node in Solarbit, all it takes is making an appropriate cable and picking the voltage output corresponding to your board specs. In this case, I made an XT30 to 5mm barrel jack cable for the RockPro64. To mount the board, I designed a universal board mount for Solarbit, currently compatible with: -Rockpro64 -Raspberry Pi 4&5 -BitPirat Gen 3 There's still room left on this mount, so feel free to suggest other boards for even broader compatibility.

Aber ohne Staat, wer baut dann die Radwege?

Rockstar go brrr

I've had that conversation before. 🤣

Yes please!

GM Sir!

Feel free to reach out if you wanna chat about printers anytime.

You too!

Rockstar was caught red handed here. Unfortunate but I've had this happen before with other prints. These errors and the obvious reduction in time and especially waste was what made me go full toolchanger and get the XL, but I understand it's not for everyone. The bits which printed look good though. If you print single color you can get away with very little tree supports too.

Walk the pain away